← HOMEMICROTRUS INTERNATIONAL

HeelCalc

Different Pitches • Matching Fascia

Roof A — Fixed Heel

Roof B — Matching Heel

FFIISS input: 800 = 8″ • 2 or 2400 = 2′-0″

REQUIRED HEEL — ROOF B

0′-10″
Heel adjustment: +0′-2″
Where to measure the overhang
Actual overhang measurementPlumb-cut top chord, subfascia and finish fascia. Actual overhang is the horizontal distance from outside bearing wall face to outside finish fascia face. The top outside fascia edge lies on the top chord plane. Actual overhang Outside face offinish fascia Subfascia Top chordHeelBearing wall
Measure to the outside of the finish fascia — not the end of the truss.

Assumes equal bearing elevations and plumb fascia, with the top outside fascia edge in the top chord plane. Heel is measured vertically from bearing to top chord at the outside wall line. Reference geometry only; results rounded to nearest 1/16″.

HeelCalc Input Examples

HeelCalc uses the common truss-design ffiiss format: feet, inches, sixteenths. Just type the numbers—no feet, inch, or fraction symbols.

22′-0″
24002′-0″
8008″
8088 1/2″
1041 1/4″
106081′-6 1/2″
501125′-1 3/4″
24080024′-8″
1040815104′-8 15/16″

Quick rule: The last two digits are sixteenths, the two before those are inches, and everything to the left is feet. One- or two-digit entries are whole feet. As in TrusCalc, inches and sixteenths carry into the next unit when needed.

Pitch is a regular number (e.g. 6 for 6/12). Results use architectural format.