← HOMEMICROTRUS INTERNATIONAL

TrusCount

Truss Count • Spacing • Layout

Building

Layout

FFIISS input: 30 = 30′-0″ • 108 = 1 1/2″ • 2400 = 2′-0″

TRUSSES REQUIRED

—
Plan view
Truss layout plan viewPlan view of the building with each truss centerline drawn across the width.
Gold = truss centerlines • green = short bay

Truss positions (to centerline, from outside face of end wall)

#From start endFrom far endBay to next

Reference layout only. Counts include both end trusses and do not add girders, ladders, jack, or hip-end trusses. Positions are to truss centerlines and rounded for display. Always verify against the truss design drawings.

TrusCount Help

TrusCount uses the common truss-design ffiiss format: feet, inches, sixteenths. Just type the numbers—no feet, inch, or fraction symbols.

3030′-0″
2828′-0″
1081 1/2″
24002′-0″
16001′-4″
30060030′-6″
45100845′-10 1/2″

Quick rule: The last two digits are sixteenths, the two before those are inches, and everything to the left is feet. One- or two-digit entries are whole feet. As in TrusCalc, inches and sixteenths carry into the next unit when needed.

Building length is outside face to outside face of the end walls, measured along the direction the trusses are spaced.

End trusses — flush: the face of each end truss is flush with the outside of its end wall, so the first and last centerlines sit half a truss thickness inside the building length. Centered: the end truss centerlines sit exactly on the end wall lines.

Full spacing from one end: trusses at the maximum spacing starting from the first end, with one shorter bay at the far end. From both ends: full spacing from each end with the shorter bay near the middle. Equal bays: every bay the same size, never larger than the maximum spacing.

Minimum clear gap is the narrowest bay minus truss thickness. A negative value means the trusses overlap.